Cue Tip Repair Kit

If you do your own tip work, this lightweight cue tip repair kit gives you the tools you need in one simple setup. The integrated ferrule leveler, side cutter, and shaper let you move smoothly from trimming to shaping without switching tools. Its wrap-around design locks onto your cue with four contact points per side, helping prevent slipping while you work. Designed to handle tip sizes from 9mm to 13.5mm, it is a reliable addition to any player’s case. From shaping a new tip to cleaning up an old one, it helps you get a consistent, balanced finish every time.

Tool Instructions

Cue Ferrule Leveler

Slide the tool over the shaft and tighten it just enough to hold it securely in place. Do not overtighten, as this can damage the shaft or ferrule. Rotate the tool slowly using light, even pressure to level the ferrule surface before installing a new tip.

Cue Tip Side Cutter

Secure the tool with light pressure and rotate it slowly around the cue. Use the Pre-Cut Blade to remove excess tip material, then switch to the Finish-Cut Blade for a smooth, flush cut where the tip meets the ferrule. Work slowly and check your progress frequently to avoid removing too much material.

Cue Tip Shaper

Position the tool over the shaft and lightly secure it in place. Rotate the shaper with light, even pressure to shape the tip to your preferred radius. Check your progress often and remove material gradually for the best results.